Accton Cheetah Power Enhanced 10/100 Adapter AC-EN3207

Windows device driver information for Accton Cheetah Power Enhanced 10/100 Adapter AC-EN3207

This Accton cheetah power enhanced adapter features an enhanced manageability including a remote system alerts. This makes it easier for administrators to monitor PC’s for intrusion, temperature level drops, boot failures and voltage interruptions. It also has an on board managed PC boot agent for improved remote wake up capabilities which allows network administrators to remotely install software, configure computer and also backup hard drives. It also comes with management features that allow power back up from a centralized area of management. This allows the computer to boot from network before loading the operating system. This remote wake feature will respond to magical packet signal sent from a remote management. The adapter offers ease of use with a Microsoft windows software diagnostic for easy installation and LEDs that indicate the strength of the link for both 10 Mbps and 100 Mbps.

This adapter has a width of 3.00 inches (7.62mm), depth of 5.85 inches (14.86mm) and requires a power requirement of 5v maximum. It then requires a maximum of 3.3v when it is at sleep mode and 5v when connected to an external source. It can operate on temperatures of between 32 degrees Fahrenheit and 104 degrees Fahrenheit with a relative humidity of just about 20% to 80% none condensing. The adapter requires drivers at ether disk level 5.0 or above. Some configurations may not support this. The cables operating distances include a 10BASE-T category 3, 4 or 5 UTP on two pairs up to 100m (328ft) and 100BASE-TX category 5 UTP on two pairs up to 100m (328 ft). It’s takes relatively 30 minutes to install. Its delivery package comes with an adapter card, a wake on LAN cable and safety guide. It is highly recommended you run a free registry scan for and Accton Cheetah Power Enhanced 10/100 Adapter AC-EN3207 errors before installing any driver updates.