Nec i-Select D3210 VIA Rhine II driver 3.18

Windows device driver information for Nec i-Select D3210 VIA Rhine II driver 3.18

The model is a networking card that allows computers to be connected to each other either through the internet or through intranet. The Rhine II network card has its own original MAC address. The network card is made up of 10/100 Mbps controllers for the PCI bus interface. The network card enables compatible devices to transfer data at very high speeds. The network adapter has either an ANI or BNC socket where users are able to connect the network cable to be able to activate the network. The Rhine II has an Ethernet Network Interface Controller (NIC), which acts as a hardware interface. NIC is responsible for handling and granting network compatible devices, access to the computer network. The network may include a Local Area Network (LAN) as well as the internet. The network adapter is also compatible with plug and play devices.

Nec i-Select D3210 VIA Rhine II controller enables system designers to easily integrate the networking chip with advanced features for power conservation, which enables it to use low power. The design of the D3210 VIA Rhine II enables it to fully utilize the NIC and PCI bus throughputs, making it use a lower percentage of the Central Processing Unit (CPU). In addition, it is able to transfer data at maximum high speeds of 200 Mbps when in full duplex. The D3210 VIA Rhine Ethernet adapter is fully compliant with the Institute of Electrical and Electronic Engineers (IEEE) 802.3 standardization mark. The network card has three slots for PCI bus masters and a single AGP slot. The Nec i-Select D3210 VIA Rhine II network adapter has two DIMM sockets for both memory models DDR 333 MHz and DDR 266 MHz. Users should use the most recent driver update for the network card to function properly. It is highly recommended you run a free registry scan for and Nec i-Select D3210 VIA Rhine II driver 3.18 errors before installing any driver updates.