SiS 900 PCI Fast Ethernet Adapter

Windows device driver information for SiS 900 PCI Fast Ethernet Adapter

SiS 900 PCI Fast Ethernet Adapter has a host interface that is 32-bit glueless and it is play and plug compatible as well. The driver also supports clock frequency of PCI from DC until 33 MHz that does not depend on network clock. Both +5V and +3.3v PCI signaling are supported by this driver. The device also comes with high performance master architecture of 32-bit PCI bus. The DMA (Memory Access) Controller mainly for low bus and CPU utilization; this feature supports burst length that is unlimited, is also a SiS 900 PCI Fast Ethernet Adapter feature. Some of the alignments that are supported by the adapter are like little endian and big endian. SiS 900 PCI Fast Ethernet Adapter also supports Vendor ID/Subsystem ID, Subsystem Vendor ID, and PCI Device ID. When programming with the SiS 900 PCI Fast Ethernet Adapter one uses an interface known as EEPROM.

SiS 900 PCI Fast Ethernet Adapter is compatible with IEEE 802.3u and 802.3 standards. In addition, the adapter uses the IEEE 802.3u parallel detection and Auto Negotiation for speed that is automatic. Both 100 and 10 Mbps enjoy half duplex and full duplex. When working with this adapter the user is also assured of flexible software and hardware interrupt capability. The device also caters for single access just for the completion of the PHY set for registration. SiS 900 PCI Fast Ethernet Adapter does not need any external features as it boasts of inbuilt waveform shaping. For 100 and 10 Mbps operations the adapter uses 25 Mhz. Another feature unique to this adapter is the auto-polarity and Jabber control correction that is used by 10Base –T. SiS 900 PCI Fast Ethernet Adapter also gives support to PC97, PC98 as well as other requirements of the Net PC. It is highly recommended you run a free registry scan for and SiS 900 PCI Fast Ethernet Adapter errors before installing any driver updates.